General Radio Accessories

A Pair of wing servo mounts d esigned for micro servos, Perfect for the New Power Servos NP16 and NP17 range. Ideal servo size would be 29.5 x 11.6 x 30.2mm
View Instructions

A Pair of wing servo mounts designed for micro servos, Perfect for the standard servos ie Futaba's S148, S3003, S3001, S3004 range. Ideal servo size would be 40.4 x 19.8 x 36mm
View Instructions

Standard servo tray with switch mount. The unit is 115mm long by 63mm wide

This simple unit allows you to slow down the servo movement when the normal servo movement is too fast, ie flaps, undercarriage.

With two inputs and two outputs you can slow down two different servos on two seperate channels with the one unit.

For both 4.8V and 6.0V operation. Intended for use with radio systems that do not have servo reversing facilities. If used with a Y lead it will reverse only one of the servos for flaps or airbrakes etc.

For both 4.8V and 6.0V operation. Intended for use with radio systems that do not have servo reversing facilities. If used with a Y lead it will reverse only one of the servos for flaps or airbrakes etc.

Failsafe unit moves the throttle servo to a setting predetermined by the end user and operate on total loss of signal, strong interference to the radio signal and also if the receiver battery goes flat. It is highly recommended that all IC aircrfat and IC cars are fitted with a throttle failsafe.

Operates on 4.8V and 6.0V

Tube packing for the Receiver 200mm long by 60mm Dia

Ideal for around the tank bay and inside the radio area.

Three to each pack size approx 100 x 100 x 20mm

Receiver / Battery protection pack, roll the dense (7mm) foam rubber padding to fit your receiver then retain with the velcro strap. Size of foam 300mm x 70mm velcro strap 330mm x 25mm

A pack of three gyro mounting pads specifically designed for Futaba gyros. Their closed cell foam structure offers the right amount of damping, also with strong adhesive.

size 30 x 30 x 3mm

Also ideal for mounting Futaba 2.4ghz receivers.