1. Tel 01633 682795 Mon-Fri 9:30am-3pmHome
  2. Login
  3. Order Status
  4. View Basket
  5. Checkout

MacGregor MG7245HV 45.9kg/0.10s HV Digital Servo

MacGregor MG7245HV 45.9kg/0.10s HV Digital Servo

Ref: MG7245HV

Brand: MacGregor

MacGregor MG7245HV 45.9kg/0.10s HV Digital Servo

The MG7245HV is part of MacGregor's new range of high voltage digital servos. This high voltage, high torque servo has been designed for use with large scale & aerobatic aircraft.

Battery chemistries such as Li-Po, Li-Ion, and Li-Fe have become very popular within the RC community. They are the standard for powering electric motors and have also gained popularity as receiver battery packs. The issue is the output voltage of these batteries is higher then the previous standard 4 - and 5-cell NiCd and NiMH packs, 4.8V and 6V respectively. The higher voltage is not an issue with the receivers but can be for the servos. Many servos will not operate at these higher voltages for very long before burning out the motors or electronics.

To get around this issue modellers have had to use a regulator to drop the voltage to an acceptable operating range for their servos, usually around 5 to 6 volts. The addition of a regulator adds a component that, should it fail, can cause the loss of a model.

MacGregor's HV servos are designed with motors and electronics that operate off the direct voltage of a 2-cell Li-Po, Li-Ion, or Li-Fe receiver battery pack. This eliminates the need for a regulator and lowers the chance for a power failure that can cause a catastrophic failure of your model. Also note that the HV servo specs are shown at the higher voltage (8.4V 2S LiPo) but will still operate on a standard 5-cell 6V NiCd, Ni MH battery with a reduction in performance of approximately 10% in speed and torque.


Dead band: 1µs 1520µs / 330hz

Pulse Width: 1000-2000µs = 90°

Pulse Width: 500-2500µs = 180°

Motor: Brushless Motor

Operating Speed (6.0V): 0.12sec/60°

Operating Speed (8.4V): 0.10sec/60°

Stall Torque (6.0V): 38.6kg.cm

Stall Torque (8.4V): 45.9kg.cm

Dimensions: 40.5 x 20.5 x 36mm/1.59 x 0.80 x 1.43in

Weight: 72g (2.48oz)

Connector Wire Length: JR 265mm (10.43in)

Bearing: 2BB

Supplied with fitting hardware and a selection of arms

Price: £74.50 (Including VAT at 20%)

Recently Viewed