Sorry we're out of stock!
Enter your email address below and we’ll notify you as soon as it becomes available.
- Description
The MG2810HV is part of MacGregor's range of high voltage digital servos. This high voltage servo has superceeded the MG2607HV. Take note of the dimentions as it is slightly smaller than a standard servo.
MacGregor's HV servos are designed with motors and electronics that operate off the direct voltage of a 2-cell Li-Po, Li-Ion, or Li-Fe receiver battery pack. This eliminates the need for a regulator and lowers the chance for a power failure that can cause a catastrophic failure of your model. Also note that the HV servo specs are shown at the higher voltage (8.4V 2S LiPo) but will still operate on a standard 5-cell 6V NiCd, Ni MH battery with a reduction in performance of approximately 10% in speed and torque.
Features:
High performance high voltage coreless digital servo
High-precision metal gears with hard anodising
Dual Bearing Support
Metal centre case to act as a heat sink
Ideal for 450-500 class Helicopter swashplate
JR style lead and plug
25 tooth spline (Futaba style)
Specifications:
Dead band: 1µs
Working frequency: 1520µs / 330hz
Motor: Coreless Motor
Operating Speed (5.0 / 6.0 / 7.4 / 8.4V):0.12 / 0.10 / 0.08 / 0.07s/60⁰
Stall Torque (5.0 / 6.0 / 7.4 / 8.4V):6.6 / 7.4 / 9.0 / 10.0kg.cm
Dimensions: 35 x 15 x 29mm /1.38 x 0.59 x 1.14in
Weight: 28g (0.99oz)
Connector Wire Length: JR 260mm (10.14in)
Bearing: 2BB
Supplied with fitting hardware and a selection of arms